Plaster 138-142 Technology Overview

Note: This article applies to all Plaster classrooms except 201.

• On the wall, there is an input controller for the display. The controls, starting with Power Off and going clockwise, are as follows:
  • Power off
  • Volume up
  • Hide projector display (does not power the system off)
  • Volume down
  • AirServer (for wireless connection)
  • White Board
  • HDMI
• (NOTE: press the buttons next to the display, not the display itself)

• Power on: select an input (HDMI, White Board, or AirServer).
• Power off: select the OFF button.

To project with optional PC Interactivity (touch capabilities),

• Power the system on via the HDMI button on the projection controller.
• Connect your PC or Mac via HDMI and USB.
• Make sure that the PC Interactivity toggle is ON on the projector display:

To project wirelessly,

• Power the system on via the AirServer button on the projection controller.
• On PC,
  • Press the Windows key and K at the same time.
  • Select the classroom name (i.e. Plaster 138) to project.
• On Mac,
  • Open Control Center from the menu bar and select Screen Mirroring:
  • Select the classroom name (i.e. Plaster 138) to project.

To use the Digital White Board,

• Power the system on via the White Board button on the projection controller.
• Use your finger or the stylus to write or draw.

NOTES:

• Do not use a dry-erase marker on the projection screen (middle board).
• Room lights turn on with motion. There is a switch next to the door that you can control brightness.
• Window blind controls are next to the windows. The top and bottom buttons raise and lower the blinds completely. The middle buttons let you control how high the blinds stop.